All options can be abbreviated to their shortest unique prefix. You may use two hyphens instead of one to designate an option. You may use either white space or an equals sign between an option name and its value.
This program is part of Netpbm.
ppmdraw draws lines, shapes, text, etc. on a PPM image. It is essentially an easy-to-program front end to libnetpbm's "ppmd" subroutines. It lets you create a human-friendly script to describe the drawing rather than write a C program.
You supply drawing instructions with a script, which you supply either in a file named by a -scriptfile option or as the value of a -script option. Here is an example script:
setpos 50 50;
text_here 10 30 "hello";
setcolor black;
text_here 10 0 "there";
line_here 5 20;
This example starts at Column 50, Row 50 of the input image and writes the word "hello" there in 10 pixel high white letters at a 30 degree angle up from horizontal. Then, from where that leaves off, the script writes "there" in 10 pixel high black letters horizontally. Finally, it draws a black line to a point 5 pixels over and 20 pixels down from the end of "there."
If you don't specify ppmfile, ppmdraw reads its input PPM image from Standard Input.
The output image goes to Standard Output.
ppmdraw works on multi-image streams. It executes the same script on each input image and produces an output stream with one image for each input image. But before Netpbm 10.32 (February 2006), ppmdraw ignored every image after the first.
If you just want to add a single line of text to an image, ppmlabel may be more what you want.
You may not specify both -script and -scriptfile.
You may not specify both -script and -scriptfile.
You may not specify - (Standard Input) for both -scriptfile and the input image file.
The heart of ppmdraw function is its script. The script is a character stream. The stream consists of commands. Commands are separated by semicolons. White space is regarded just like in C: Any contiguous stretch of unquoted white space is equivalent to a single space character. Note that this means newlines have no particular significance.
A command is composed of tokens, separated from each other by white space. To write a token that contains white space, enclose it in double quotes. Everything between two matched quotation marks is one token.
The first token of a command is the verb, which determines the basic function of the command. The rest of the tokens of the command are arguments, the meaning of which depends upon the verb. The following list gives all the valid verbs, and for each its meaning and its arguments.
At the start of the script, the current position is (0,0).
The argument of this command is a file name. It is the name of a Netpbm PPMD font file.
A Netpbm PPMD font file typically has a name that ends in ".ppmdfont" and its first 8 bytes are the ASCII encoding of "ppmdfont".
There is only one of these fonts as far as we know. It is distributed with Netpbm as the file standard.ppmdfont, but you don't need to use that file because the same font is built into the Netpbm library and is the default. If you want to make a new font, you can find the format of a ppmdfont file in the Netpbm interface header file ppmdfont.h, but you'll have to make your own tools to build it.
This command does not affect the current position.
The line starts at the current point. The two arguments are the rightward and downard displacement from there of the terminal point. The command moves the current position to the terminal point after drawing.
This command does not affect the current position.
Note that if your text contains white space, you'll have to use double quotes to cause it to be a single token.
Bear in mind that a script starts with the current position in the top line, so if you leave it there, only the bottom line of your text will be within the image!
ppmdraw was new in Netpbm 10.29 (August 2005).