spottopgm

Updated: 22 July 2004
Table Of Contents

NAME

spottopgm - convert SPOT satellite images to a PGM image

SYNTAX

spottopgm [-1|-2|-3] [Firstcol Firstline Lastcol Lastline] inputfile

OPTIONS

-1
-2
-3: Extract the given color from the SPOT image. The colors are infrared, visible light, and ultraviolet, although I don't know which corresponds to which number. If the image is in color, spottopgm announces this on Standard Error. The default color is 1.

PARAMETERS

Firstcol Firstline Lastcol Lastline: Extract the specified rectangle from the SPOT image. Most SPOT images are 3000 lines long and 3000 or more columns wide. Unfortunately, the SPOT format only gives the width and not the length. The width is printed on standard error. The default rectangle is the width of the input image by 3000 lines.

DESCRIPTION

This program is part of Netpbm. spottopgm converts the named inputfile to PGM format, defaulting to the first color and the whole SPOT image unless you specify otherwise with the options.

LIMITATIONS

spottopgm doesn't determine the length of the input file; this would involve two passes over the input file. It defaults to 3000 lines instead.

spottopgm could extract a three-color image (as a PPM), but I didn't feel like making the program more complicated than it is now. Besides, there is no one-to-one correspondence between red, green, blue and infrared, visible and ultraviolet.

I've had only a limited number of SPOT images to play with, and therefore wouldn't guarantee that this will work on any other images.

AUTHOR

Warren Toomey [email protected]